DODGE Viper SRT/10 (2003-2010) Stainless Steel Polished Wiper Cowl Upgrade – 8pc set

Description

WOW! What a difference when you see this on!

Eight-piece set of extremely high-polished stainless steel Wiper Cowl Covers.
This upgrade fits directly in the area between your windshield and the hood.
It really enhances the look of your car and is always a hit at car shows!
The design leaves your black cowl vents black, creating a striking contrast with the chrome-like finish.
These covers will never rust or corrode and feature easy peel-and-stick installation.
They can also be removed at any time.

INCLUDED:

• 8 x Wiper Cowl Trim Pieces
• 2 x Promoter Packets
• 1 x Tape Test Stick Kit

READ BEFORE MOUNTING:

1. It is critical that you thoroughly clean the surface where you will be mounting the trim.
   Wash the area with soap and water, then use rubbing alcohol to scrub it thoroughly.
   Any wax, oil, or residue will prevent proper adhesion.
2. Once the surface is clean, use the Test Stick Kit (included).
   Peel back the red liner from the small piece of tape and test the adhesion by sticking it to the surface in several locations.
   Stick and pull off. If the tape sticks tightly, your surface is ready for mounting.
3. Take out your Windshield Cowl Trim pieces one by one.
   Without removing the backing liner, place each piece against the mounting area.
   If necessary, gently bend each piece to match the contour of the body.
   Familiarize yourself with the fit before installing the trim permanently.
   Repeat this for all pieces.
4. Open the Promoter Packet and use the moistened towelette to wipe down all areas where the trim pieces will be mounted.
5. Note: Once you remove the red liner, the product cannot be returned.
   Remove the red liner from the first Windshield Cowl Trim piece carefully, avoiding contact with the adhesive.
   Hold the piece about half an inch above the mounting surface and align it properly.
   Slowly and gently lower it into place without pressing down.
   Make any necessary adjustments, then press down firmly across the entire surface to ensure full adhesion.
   Repeat this process for all remaining pieces.