Dodge Viper Gen 2 Center Dash Gage Trim Inner and Outer Rings – 8pc

Description

Mirror-polished stainless steel gauge trim rings for the top center instrument panel gauges. Includes inner and outer trims for the four gauges on the top center dash. Total of 8 pieces.

Make your interior show-car worthy! What a difference this kit makes. Made of pure, bright, shiny heavy-gauge stainless steel with a high-polished finish. It will not rust, corrode, or lose its luster. Everything you need is included. Easy to install — just peel and stick.

IMPORTANT! – READ THIS BEFORE YOU INSTALL YOUR TRIM PART(S)

SPECIAL PREPARATION INSTRUCTIONS for Mounting ALL Interior Trim Parts

In many situations, interior panels and surfaces become saturated with silicone-based chemicals such as Armor-All (even if applied years ago) or other forms of residue. Although these treatments make the surface look nice, the chemicals become embedded in the ABS plastic of your door panels or dashboard. These must be removed to ensure proper bonding of your new trim parts.

This removal can take some effort; the best way we’ve found is to apply several different solvents to break down these chemicals.

NOTE: Apply this cleaning process only to the surface areas inside your vehicle where you will be attaching your new interior trim parts.

STEP 4. Once you have completed these steps, apply a single thin swipe of the adhesive promoter in either a wipe format or a sponge-tip pen (provided with your accessory). This clear, odorless liquid will prepare the surface for a tight, permanent stick. Allow 2 minutes to dry.

Now, continue with your installation.

STEP 5. Once the strip readily sticks to the surface, take your trim piece (without removing the front clear liner or the rear red liner) and hold it up to where you will mount it. Check the fit. Many pieces need to be hand-bent to match the contours of the interior panel. The trim piece should fit exactly to the contours. Bend, lay it in place, and continue this process until the piece lies in place perfectly.

STEP 6. Peel off the back red liner and hold the piece over the area where it will be mounted, then slowly set it down in place. Make any last small adjustments.

Once it fits perfectly, push down along the surface of the trim piece to form a tight stick.

STEP 7. Now you may peel off the front clear liner.