Viper Gen 2 (6 -pc) Engine Manifold Chrome Vinyl Strips© set of 6 Vinyl strips

Description

These chromed high-tech vinyl strips with tapered, rounded edges really dress up your engine. They have been a big hit at Viper rallies! The six strips fit directly on top of the existing strips on your engine’s manifold. Unlike the original dul,l expos, ed brushed steel strips, these vinyl chrome strips stay shiny. They are heat-resistant. Self-adhesive on the back of each strip makes installation easy. Includes six strips with beveled edges, six 5/8 inch wide strips. When installed properly, they will stay put and will not come off due to heat, cold, or vibration.

Installation Instructions

Items Needed: Household rubbing alcohol, straight razor blade, pencil

Items Included: 6 x chrome strips, 1 x adhesive promoter packet

WARNING: It is extremely important to follow the steps below to ensure that your new part bonds permanently and professionally. Do not skip any of the prepping procedures.

1. With a damp, soapy cloth, remove any road grime and dirt from your valve covers on the engine’s exposed aluminum ribs. Then scrub with,h household rubbing alcohol and let it dry.
2. Wipe the area with the adhesive promoter (provided). This liquid is sticky and sets up fast. Be careful when opening the packet as the liquid can spill and cause stains or damage surfaces. Avoid contact with your hands or body. Wash your hands immediately if contact occurs. Pull the sponge-like piece out of the packet and carefully wipe the area where you will stick the Beauty Strips. Wipe away any excess liquid on the engine.
3. Mark with a pencil the exact position of the throttle plate. Remove the two retaining bolts holding down the throttle plate and set the bolts and plate aside. Starting from the front of the motor, place the rounded side of the chrome trim and work toward the back of the valve cover (toward the windshield), as straight as possible, removing the red liner as you go. Press firmly down the length to set. Repeat for all six strips.
4. Reposition the throttle plate at the previously marked area and mark the chrome trim on both sides of the throttle plate, then remove the plate again. Using a straight razor, cut the chrome molding at the two marks you just made and remove the section of molding so the throttle plate can be repositioned. Reinstall retaining bolts.