Description
Mounts directly on the swivel vents themselves. Mirror-polished stainless steel environmental control (A/C) trims for the center dash instrument panel.
Make your interior show-car worthy! What a difference this kit makes. Made of pure, bright, shiny heavy-gauge stainless steel with a high-polished finish. It will not rust, corrode, or lose its luster. Everything you need is included. Easy to install — just peel and stick.
IMPORTANT! – READ THIS BEFORE YOU INSTALL YOUR TRIM PART(S)
SPECIAL PREPARATION INSTRUCTIONS for Mounting ALL Interior Trim Parts
Over time, interior panels can become saturated with silicone-based chemicals such as Armor-All or other surface treatments. These products, even if used years ago, can embed into the ABS plastic of your door panels or dashboard. Before installing your trim parts, this residue must be completely removed for proper adhesion.
This removal may require several cleaning steps using different solvents to break down the embedded chemicals.
NOTE: Clean only the surface areas where the new trim parts will be applied.
STEP 4. Once you have completed these steps, you can then apply a single thin swipe of the adhesive promoter in either a wipe format or a sponge tip pen (provided with your accessory). This clear odorless liquid will prepare the surface for a tight stick for a permanent installation. Allow 2 minutes to dry.
Now, continue with your installation.
STEP 5. Once the strip readily sticks to the surface, take your trim piece (without removing the front clear liner or the rear red liner) and hold it up to where you are going to mount it. Check the fit. Many pieces need to be hhand-bentto to match the contours of the interior panel. The trim piece should fit exactly to the contours. You bend it, lay it in place, and continue this process until the piece lies in place perfectly.
STEP 6. Peel off the back red liner and hold the piece over the area where it is to be mounted, and slowly set it down in place. Make any last tiny adjustments.
Once it is where it fits perfectly, then push down along the surface of the trim piece to form a tight stick.
STEP 7. Now you may peel off the front clear liner.
Reviews
There are no reviews yet.