SRT Viper “Medium” Raised Emblem 640HP, 700 HP or Special Edition

Description

Let them know how much power is coursing through your Viper!

Chrome raised vinyl letters indicating the horsepower of your vehicle. This item includes one emblem — choose from 640HP, 700HP (for performance modifications), or the Special Edition. Each emblem features chrome letters with no background and measures approximately 4 inches long.

Stock Vipers:

2013–Current = 640 HP (factory standard) (1/2″ x 5 3/4″)
2013–Current = 700 HP (with performance modifications)
2013–Current = Special Edition (6″ x 3/4″)
Includes one emblem.

Applying your new logo(s):

1. First, wash the area where your current logos will be replaced using soap and water. Let it dry for a few minutes.
2. IMPORTANT: Next, scrub the area thoroughly with rubbing alcohol to remove any invisible oils.
3. Open the packet or small pen of “promoter” provided. Apply the clear, moist promoter to the exact area where you will mount your emblem(s). The promoter will not damage your car’s paint, and any excess can be wiped away with rubbing alcohol. The foil packet contains a moistened sponge inside. If you are using the pen applicator, bend the pen so the glass ampoule inside breaks. Then press the spongy tip against a clean piece of paper to start the liquid flow before applying it to your surface.
4. Use the pink scraper (included in your kit) to gently pry off and remove the existing emblem(s) from your car.
5. Once you have removed the emblem, you may see faint residue outlines where each letter was. These will help you align your new logos.
6. Now it’s time to install your new emblems. Hold the emblem up to where you want to mount it and decide the exact placement. Whoever installs the new logos should ensure they are straight (perpendicular to the ground).
7. Use the provided test tape (or regular masking tape) to check adhesion by sticking it to the cleaned surface in several spots. If it sticks well, continue to the next step. If not, re-clean until it adheres properly.
8. Gently peel the white backing paper off one of your new emblems (Diagram A). The logo will remain attached to the clear top liner.

Hold the emblem where you want to mount it without touching the car at first to get comfortable with the placement. Once you are sure, lightly touch the logo to the car’s surface and make any small final adjustments. When satisfied, press down firmly on the entire surface of the logo to ensure a tight bond.

Now, very gently remove the top clear liner (Diagram B).

Finally, wipe down the letters and the surrounding car surface. Any residue left over from the original logos can be removed with rubbing alcohol.