DODGE Viper SRT/10 (2003-2010) Stainless Steel Side Mirror Trim Set of 2

Description

This high-quality, highly polished stainless steel trim overlay really enhances your Viper side mirrors! Viper SRT.

This peel-and-stick overlay looks classy and adds a sleek finishing touch to your car. It will not rust or corrode and stays shiny forever.

It’s a must-have for car shows as well!

Included:

• 2 x Side View Mirror Trims (one right side, one left side)
• 1 x Promoter Packet
• 1 x Test Stick Kit

READ BEFORE MOUNTING

1. Count the pieces in your kit to ensure there are two. Place each piece on the corresponding mirror to familiarize yourself with the correct placement and identify the right and left sides. If the trim does not fit exactly, STOP and give us a call at 352-688-8160.
2. Thoroughly clean the surface where you will be mounting the trim. Wash the area with soap and water, then use rubbing alcohol to scrub it thoroughly. Any wax or oil residue will prevent proper adhesion.
3. Once the surface is prepared, use your Test Stick Kit (included). Peel back the red liner from the small piece of tape and try sticking a corner of it to the mounting surface. Test it in several spots. If it sticks tightly, your surface is ready for installation.
4. Take out your Side View Mirror Trims (without removing the back liner) and hold them against the mounting area. If necessary, gently bend the trim pieces to match the contour of the mirror. Familiarize yourself with the fit and positioning. Repeat this process for both sides.
5. Open the Promoter packet, remove the moistened towelette, and wipe down the areas where you will mount the trim pieces.
6. Note: Once you remove the red liner, you cannot return the product. Carefully remove the red liner from the back of the first trim without touching the adhesive. Hold it about half an inch above the mounting surface and align it carefully. Slowly and gently lower the trim into place. Do not press it down yet—make any necessary adjustments. Once satisfied with the alignment, press firmly along the entire trim surface to secure it.
7. Repeat the same process for the other side.