Dodge Viper SRT-10 (2003-10) Stainless Steel “BUMPER” Emblems

Description

High-polished stainless steel emblems designed to replace your factory plastic emblems on the rear bumper. These will never rust, corrode, or lose their luster.

Remove your factory plastic emblems easily using the included tool.

Easy peel-and-stick installation — stays firmly in place until you decide to remove it.

Includes one “VIPER” and one “DODGE” letter set.

SIZE: Approximately the same size as the stock bumper logo.

Included: Map, promoter packet, pink emblem remover tool, and emblems.

1. Wash the area where you’ll mount the emblems with soap and water. Then wipe it down with rubbing alcohol to remove any oils on the paint surface. This will not harm your paint.
   If you’ve recently waxed your car, wash the area with an isopropyl solution (available at most hardware stores). Any wax, oil, or fingerprints on the surface will prevent proper adhesion.
2. Removing the old emblem: Use masking tape to outline the emblem on the bottom and left sides (not the right side). This will serve as a placement guide for your new emblem. The tape should form an “L” shape. (See Diagram 1.)
3. Take the pink scraper (included) and carefully slide it under the old emblem (Diagram 2). The tool should remove it easily without scratching the paint.
4. With the masking tape still in place as a guide, remove the backing from your “map” sheet and stick it onto the car, aligning it over the masking tape. Once it’s properly positioned, peel off the front clear sheet from the map.
5. Important: Some mounting surfaces may be curved. Gently bend the new emblem letters to match the contour of the car surface. Test-fit each piece to ensure proper alignment. (See Diagram 3.)
6. Hold each new emblem letter (without peeling off the backing) up to its spot on the map to get familiar with the placement.
   Note: You can also mark small tick marks on the masking tape with a pencil for precise letter positioning.
   Once you’re satisfied, use the included promoter packet to wipe the area inside each letter on the map where the new emblems will mount. This won’t harm your paint.
7. Peel off the liner from the back of each new emblem letter and carefully position it in place. Gently set it down without pressing immediately. Make any final adjustments (see Diagram 3), then press firmly over the entire surface of each letter to form a strong bond.
   Repeat for all letters. Finally, remove the map sheet and masking tape — you’re done!