Description
Only available at TheViperStore.com
The stainless steel, highly polished Viper V-10 Engine Plenum Trim sits on top of the engine manifold. Mounted using professional-grade automotive self-adhesive tape on the back side. Simply peel and stick.
Heavy-duty. Easy to mount.
All stainless steel construction. Will not rust or corrode. When installed properly, it will stay in place and will not come off due to heat, cold, or vibration.
Viper SRT/10 Polished Stainless Steel Plenum Trim
Part # ACC-973011
Installation Instructions
Parts Included:
- 1 – Stainless Steel Plenum Trim
- 1 – Adhesive Promoter Packet
- 1 – Tape Test Stick Kit
- Wait until the engine is cool. Then clean the top of the engine manifold with alcohol to remove all road grime and dirt.
- Place the Plenum Trim on top of the engine manifold where it will be mounted and check the fit. Make sure all areas sit flush with the manifold. You may need to slightly bend some corners to achieve a proper flush fit. Slightly bend down the front center tab if necessary. Use your hands only for bending. Test fit again and repeat until satisfied. Once the trim is adhered to the manifold, it cannot be removed without damage.
- Open the Adhesive Promoter packet. Wipe the entire engine manifold surface with the provided towelette. This prepares the surface to properly bond with the tape on the back of the Plenum Trim.
- Remove the red backing from the rear of the Plenum Trim to expose the adhesive tape.
- Carefully position the Plenum Trim about one inch above the engine manifold. Once properly aligned, gently set it in place. Minor adjustments can be made at this stage if necessary.
- Once correctly positioned, press down firmly along the entire trim piece to ensure it sits flat and flush against the engine manifold.
- Peel off the clear protective plastic from the front of the Plenum Trim.
