Description
High-polished stainless steel trim rings for each front fog light. Set of 2.
Very easy peel-and-stick installation.
Will not rust or corrode.
When installed properly, these rings will stay securely in place and will not come off due to heat, cold, or vibration.
INCLUDED:
- 2 x Fog Light Trim Rings
- 1 x Promoter Packet
- 1 x Test Stick Kit
READ BEFORE MOUNTING:
- It is critical that you thoroughly clean the surface where you will be mounting the trim rings.
Wash the area with soap and water, then use rubbing alcohol to scrub the area and remove any wax or oil.
If any residue remains, the trim rings will not adhere properly. - Once the surface is prepared, use your Test Stick Kit (included).
Peel back the red liner on the small piece of tape and stick a corner onto the surface where the trim ring will be mounted.
Test in several locations. Stick and pull off. If the tape sticks tightly, your surface is ready for installation. - Open the Promoter Packet and use the moistened towelette to wipe down all areas where the trim pieces will be mounted.
- Take out the trim rings (without removing the backing liner) and hold them up against the mounting area.
If necessary, gently bend each trim ring to match the contour of the body.
Familiarize yourself with the fit before mounting. Repeat this for both sides. - Note: Once you remove the red liner, you cannot return the product.
Carefully remove the red liner from the first trim ring. Avoid touching the adhesive with your fingers or any other surface.
Hold the trim ring about half an inch above the mounting area, align it properly, and slowly lower it into position.
Do not press down yet. Make any minor adjustments. Once you are satisfied with the alignment, press down firmly over the entire surface.
Repeat the same process for the other side.
Reviews
There are no reviews yet.