Dodge Viper RT/10 Raised Chrome Vinyl “VIPER RT-10” & “DODGE” Emblems for Bumper for Bumper emblems replacement.

Description

There is no background. The set of letters peels off and sticks onto your car’s body. Raised three-dimensional letters, overall sizes: “VIPER RT/10″ 1 ¾” x 10″ and “DODGE” 1″ x 8″. Your stock emblem letters on your fender and back bumper peel off easily without damaging your paint. Replace them with these vinyl chrome letter logos.

What a difference these emblems make on your Viper! Will not fade, rust, or lose their luster.

You receive one VIPER RT/10 and one DODGE vinyl chrome emblem.

Size: Similar to stock bumper emblems.

Removing Old Emblem and Mounting Replacement Emblems

Mounting Instructions

1. First, wash the area on the car where you are to mount the emblems with soap and water. Next, wipe down the area with some rubbing alcohol. This will help remove any oils on the paint surface. It will not hurt your paint.
   1. Removing the old emblem: Take some masking tape and outline the logo on the bottom, top, and left side (not the right side). This will give you the outline of where to mount the new emblem. See diagram 1.
   2. Take the pink scraper included and carefully pry underneath the old emblem (Diagram 2). The tool should remove the old emblem easily without scratching your paint.
   3. Important: Some mounting surfaces will be curved. Take the new emblem and slightly bend the letters to match the curve of the car surface. Try a small bend, place the emblem on the car, and see if it fits. Adjust as necessary. See diagram 5.
   4. Now take your new emblem and, without peeling off the backing, hold it up to the spot where it is to be mounted. Become familiar with where it will mount.
2. If your emblem came with a ‘map’, stick the map (stencil) over where you want to mount the new emblem. Place the emblem letters in the spaces cut out on the map. Once completed, peel off the map. You can also mark tick marks on the masking tape if exact placement is needed.

Once you are satisfied, take your packet of promoter included and wipe the area using the damp towelette where the new emblem will mount (this will not hurt your paint).

1. Peel the liner off the back of the new emblem and carefully hold it up to the spot where it is to be mounted. Gently set the new emblem in place without pressing on it. Make any tiny adjustments needed (see Diagrams 3 & 4). Now press firmly on the new emblem all over its surface to form a tight bond. Remove the masking tape. You’re done!