Dodge VIPER (1992-2002) Head & Fog Lens vinyl Pre-cut Overlays – Clear 4-PC Set

Description

You receive four high-quality light lens adhesive vinyl overlays: one for each headlight and one for each fog light. These guards are made from 3M special 7-year vinyl, the highest quality material available. They protect against chips and cracks and are completely invisible!

Includes four pieces: headlight adhesive vinyl overlays (right and left) and fog light shields (right and left).

Viper replacement lenses will cost you at least $2,350 for one light. Protect your investment today. When installed properly, they will stay put and will not come off due to heat, cold, or vibration.

Note: Vipers with the clear plastic lens cover over their fog lights should select “covered” when ordering.

INSTALLATION INSTRUCTIONS

Included: 2 x Headlight lens film vinyl tints, 2 x Fog light lens vinyl tints, soft squeegee

For installation, you will need household rubbing alcohol, a soapy water mixture (one full spray bottle of water with a couple of drops of baby shampoo or mild dish detergent). You may also need a hair dryer.

WARNING: It is very important to follow every step without skipping anything to ensure that you mount your lens guards professionally.

1. Prepare both headlight lenses by first washing them with soap and water to remove dirt and grime. Dry completely and scrub the lens with household rubbing alcohol.
2. Test your cleaning: take a piece of masking tape and see if it readily adheres to both of your headlight lenses. If it does not, continue cleaning until it does.
3. As a test and without sticking it on, place your unpeeled headlight guard over your headlight and note its fit. This will give you an idea of how it sits on the plastic headlight lens. Note: If your headlight lens is bulbous with tight compound curves, you will need to use an electric hair dryer to heat the vinyl lens until it is soft and malleable. Once softened, it will be easier to form around complex curves.
4. Spray your mixture of soapy water directly on your car’s headlight lens and on your new headlight guard, soaking it down as you peel the release liner.
5. Once both the headlight lens and the lens vinyl tint are completely saturated, place the guard on the lens and position it into place.
6. Use the provided soft felt squeegee. Starting at the center of the light lens, work the fluid out in all directions until the lens guard has completely adhered. If you need to stretch or mold your tint around complex curves, a household hair dryer will help soften the vinyl for easier molding. There should be no air bubbles under the tint.
7. Repeat the entire process for the opposite side.
8. Repeat the entire process for the fog lights as well.

Note: Once these are removed, they cannot be reinstalled as the adhesive is compromised.