Viper SRT/10 (2006-2010) Coupe Brushed Stainless Steel Rear Grilles

Description

Super high-quality, all stainless steel rear grilles give the appearance of the race car your Viper really is. Sturdy, heavy-duty all-metal part. Easy to mount.

This product includes two grilles — one for each side.

All stainless steel metal. Won’t rust or corrode. When installed properly, they will stay put and will not come off due to heat, cold, or vibration.

Does not fit the Viper SRT-10 Convertible.

Installation Instructions

Parts Included: 2 x Stainless Perforated Rear Grilles; 2 x Adhesive Promoter Pack.

These stainless grilles are designed to add a sleek performance look to the rear valance of your Viper SRT-10.

Installation Steps:

1. Scrub the lower back edges of the valance with alcohol to remove all road grime and dirt. Apply the adhesive promoter provided to the back edges of the opening. This is crucial to ensure a strong, permanent bond of the new grille.
2. Remove the carpet pad from the trunk area and the factory battery cover to allow access to the rear of the grilles.
3. Starting with the passenger side, place the appropriate grille into the valance opening to familiarize yourself with how it will be positioned. You may reach over from the driver’s side opening to manipulate the grille from behind using both hands. A properly placed grille will align the two back corners with the edge of the opening. The center may not line up perfectly due to the curve, but it will make enough contact to bond and straighten the lower part once attached. Begin by placing the grille into the center of the valance hole at the rear corner and swing the outer end into place. Push firmly at the top and squeeze the grille and valance together to create the bond. Be thorough when pressing the areas together.
4. Thdriver’ser side is slightly easier since you can reach the rear of the grille from the battery opening. Place it in position in the same way as the passenger side and firmly squeeze the back edge to create the bond. Replace the battery cover and carpet.
5. Once the grilles are installed, take the long chrome vinyl strip and hold it up to the rear end, as it will be mounted. Once satisfied with the fit, remove the backing film to expose the tape. Use the promoter packet to wipe the area where the trim strip will be attached. Carefully line up the strip and press firmly across the entire length. Let it sit for 4 hours.