DODGE Viper SRT/10 (2003-2006) Radiator Support Grilles laser Mesh – 2pc

Description

Special Order

All stainless steel polished finish radiator supports for inside the engine bay. Cut with precision laser mesh, these pieces stand out with a stunning “wow” effect when you open the hood!

Easy installation – simply peel and stick. Requires slight bending by hand to match the air box curve.

It can easily be removed without damaging your air box.

Will not rust or corrode.

DODGE Viper SRT/10 (2003–2006)

2PC. VIPER 3 Radiator Support Grilles

Part# ACC-973014

Installation Instructions

Includes: 1 x Right Side Grille, 1 x Left Side Grille, 1 x Adhesive Promoter Packet

The 2-piece radiator support grilles are easy to install and will dramatically enhance the look of your Viper engine bay.

Installation Steps:

1. Before removing the backing liner from the tape, position each of the two grilles behind the air box so that the flat section with the attachment tape rests directly over the radiator support. Familiarize yourself with their proper placement.
2. Once you understand how they will fit, prepare the radiator support rail for attachment. Clean the top surface thoroughly using rubbing alcohol. After cleaning, wipe the areas with the adhesive promoter (provided) and let it dry for two minutes.
3. When the surfaces are prepared and you’re confident about placement, peel the red release liner from the back of the grilles and press them firmly into place. Apply even pressure along the surface to ensure a solid bond. Once installed, remove the clear protective liner to complete the installation.