Description
This high-quality, highly polished stainless steel overlay really enhances your Viper’s rear third brake light. What a difference it makes!
This peel-and-stick overlay looks classy and adds a sleek finishing touch to your car. It will not rust or corrode and stays shiny forever.
It’s a must-have for car shows as well!
Included:
- 1 x Third Brake Light Trim
- 1 x Promoter Packet
- 1 x Test Stick Kit
READ BEFORE MOUNTING
- Thoroughly clean the surface where you will be mounting the trim. Wash the area with soap and water, then use rubbing alcohol to scrub it well. Make sure there is no wax or oil on the surface, as the trim will not adhere properly if any residue remains.
- Once the surface is clean, use your Test Stick Kit (included). Peel back the red liner from the small piece of tape and try sticking a corner of it onto the mounting surface. Test in several spots. If it sticks tightly, your surface is ready for installation.
- Take out your Third Brake Light Trim (without removing the back liner) and hold it against the area where it will be mounted. If necessary, gently bend the trim piece to match the contour of the surface. Familiarize yourself with its fit and position before mounting.
- Open the Promoter packet, remove the moistened towelette, and wipe down the area where you will be mounting the trim.
- Note: Once you remove the red liner, you cannot return the product. Carefully remove the red liner from the back of the trim without touching the adhesive. Hold the trim about half an inch above the mounting area and align it precisely. Slowly and gently lower it onto the surface. Do not press it down yet—make any necessary adjustments. Once you are satisfied with the fit, press firmly along the entire surface to secure it.
