Dodge Viper SRT-10 (2003-2010) Door Sills – Stainless Steel- Highly Polished

Description

Beautiful! – Highest quality you can buy!

This is a full, super high-quality door sill that extends from the door hinge up to near the top of the window. You will not find a higher-quality Gen III door sill anywhere! It makes a stunning impression when you open the door.

Includes a chrome “Viper SRT-10” sticker and a stainless steel 3D Viper head logo. Made entirely of stainless steel, it will not rust, corrode, stain, or lose its shine.

Installation is easy—simply remove a few screws from the existing door sill area, set the new sill system in place, and reinstall the screws. It’s that simple! Guaranteed, you’ll love the look so much you’ll want to keep your doors open all the time.

Includes a set of two door sills, one for each door. When installed properly, they will stay secure and will not come off due to heat, cold, or vibration.

INSTALLATION INSTRUCTIONS

Parts Included:

• 2 × 2-piece stainless door sills (polished or brushed)
• 2 × adhesive promoter packs
• 1 × test tape kit
• 6 × 3/4″ – 6 mm button head screws
• 6 × washer-head style #8 screws (3/4″)
• 6 × decorative bolt head covers
• 2 × large “Viper SRT-10” stickers

Your new sills come with a protective liner. Do not remove the liner until prompted by the instructions.

1. Remove the three factory screws from each side of the car. Note: These will not be reused. Save them in case you remove the door sills later. Two sets of replacement screws are provided (6 × 3/4″ – 6 mm button head and 6 × washer-head style #8 screws). Use whichever set fits correctly.
2. Clean the entire sill area using rubbing alcohol. Scrub thoroughly up to and around the door catch. Apply the adhesive promoter provided to the sill area around the door catch down to the first screw position.
3. Hand-shape the door catch section of the sill so that it matches the contour of the door sill area perfectly. It should sit flat without forcing any part down. Once shaped, peel off the red release liner, position the section carefully, and press firmly against the entire surface to secure. Remove the protective liner.
4. Set the main door sill section in place over the end of the catch section and fasten it with the three replacement screws provided. Tighten snugly but do not over-tighten to avoid distortion. Once secured, remove the rear protective liner and press the three decorative chrome bolt head covers onto the screw heads.
5. Repeat this process for the opposite side.
6. Repeat steps 1–4 for the opposite side if needed.
7. Mount the included stickers in the center of each door sill floor plate.

If you have any questions during installation, please contact us at 352-688-8160 (Monday–Friday).

Note: Take care when cleaning your sills. Lightly dust them with a clean, soft cloth first to prevent scratching. Then wipe with a high-quality, streak-free glass cleaner using a new, soft cloth.