DODGE Viper SRT10 (2003-10) Stainless Steel Polished Wiper Cowl Upgrade - 8pc set

ACC-972007

INSTALLATION INSTRUCTIONS

Included:  8 pieces of Wiper Cowl Trim,  2 Promoter packets,  1 Tape Test stick kit

READ BEFORE MOUNTING---
 

1.  It is critical for you to thoroughly clean the surface where you will be mounting it.  To do this wash the area with soap and water.
Next use rubbing alcohol and thoroughly scrub the area.  If there is any wax or oil of any kind your trim ring will not stick well.

2.  Once you have completed the surface preparation use your Test Stick Kit (included).  Peel back the red liner off the small piece of tape and try sticking a corner of it on to the surface you will be mounting your Windshield Cowl.  Try it in several locations.  Stick and pull off.  If it sticks tightly your surface is ready for you to mount your Windshield Cowl Trim pieces.

3.  Take out your Windshield Cowl Trim pieces.  One by one - without removing the back liner - set it up against the area it is to be mounted.  If necessary - gently bend the the Windshield Cowl Trim pieces to match the contour of the body.  Become familiar with the way it will fit once mounted.  Now do the same for the other pieces.

4.  Take out the Promoter and rip the packet open.  Remove the moistened towlette and wipe down the areas where you will be mounting your pieces.

5.  (Note: once you remove the red liner you may not return the the product)  Take the first Windshield Cowl Trim piece and remove the rear red liner.  Be careful not to touch the rear sticky tape against anything including your fingers.   Hold the Windshield Cowl Trim piece about a half inch above the area where you plan on mounting it.  Line it up carefully. 
Slowly and gently lower the Windshield Cowl Trim piece on the surface.  DO  NOT press it down yet.  Make any minor adjustments.  Once you are satisfied with the fit press down along the whole surface firmly.

Now do the same with the other pieces.