DODGE Viper SRT/10 COUPE (2003-10) Stainless Steel Side Mirror Trim
Set of 2 (L & R)

ACC-972024
INSTALLATION INSTRUCTIONS

Included:  2 pieces of Side View Mirror (one right side, one left side), 1 Promoter packet,  1 Test stick kit

READ BEFORE MOUNTING---

1.  Count the pieces in your kit to ensure there are two.  Now take each piece and set it on the spot on each mirror.  This will familiarize you with the placement of parts and if you a right and a left.  If the trim does not fit exactly - STOP give us a call 352 688 8160.

2.  It is critical for you to thoroughly clean the surface where you will be mounting it.  To do this wash the area with soap and water.
Next use rubbing alcohol and thoroughly scrub the area.  If there is any wax or oil of any kind your trim ring will not stick well.

3.  Once you have completed the surface preparation use your Test Stick Kit (included).  Peel back the red liner off the small piece of tape and try sticking a corner of it on to the surface you will be mounting your Side View Mirror Trims.  Try it in several locations.  Stick and pull off.  If it sticks tightly your surface is ready for you to mount your Side View Mirror Trim pieces.

4.  Take out your Side View Mirror Trims - without removing the back liner - set it up against the area it is to be mounted.  If necessary - gently bend the the Side View Mirror Trim pieces to match the contour of the mirror.  Become familiar with the way it will fit once mounted.  Now do the same for the other side.

5.  Take out the Promoter and rip the packet open.  Remove the moistened towlette and wipe down the areas where you will be mounting your trim pieces.

6.  (Note: once you remove the red liner you may not return the the product)  Take the first Side View Mirror Trim piece and remove the rear red liner.  Be careful not to touch the rear sticky tape against anything including your fingers.   Hold the Side View Mirror Trim piece about a half inch above the area where you plan on mounting it.  Line it up carefully. 
Slowly and gently lower the Side View Mirror Trim piece on the surface.  DO  NOT press it down yet.  Make any minor adjustments.  Once you are satisfied with the fit press down along the whole trim surface firmly.

Now do the same with the other side.