DODGE VIPER ROCKER MOLDING TRIM 2PC

 Part# ACC-972018

INSTALLATION INSTRUCTIONS

Included:  2 x Vinyl Molding strips, 2 x  packets of promoter, ! Tape Test stick Kit

READ BEFORE MOUNTING---
 

1.  It is critical for you to thoroughly clean the surface where you will be mounting it.  To do this wash the area with soap and water.
Next use rubbing alcohol and thoroughly scrub the area.  If there is any wax or oil of any kind your trim will not stick well.

2.  Once you have completed the surface preparation use your Test Stick Kit (included).  Peel back the red liner off the small piece of tape and try sticking a corner of it on to the surface you will be mounting your Rocker Trim.  Try it in several locations.  Stick and pull off.  If it sticks tightly your surface is ready for you to mount your Rocker Trim.

3.  Take out your Rocker Trim - without removing the back liner - set it up against the area it is to be mounted.  If necessary - gently bend the the Rocker Trim piece to match the contour of the mirror.  Become familiar with the way it will fit once mounted. 

4.  Take out the Promoter and rip the packet open.  Remove the moistened towelette and wipe down the areas where you will be mounting your pieces.

5.  (Note: once you remove the red liner you may not return the the product)  Take one of the Rocker Trim pieces and remove about 12 inches of the rear red liner.  Be careful not to touch the rear sticky tape against anything including your fingers.   Hold the Rocker Trim piece about a half inch above the area where you plan on mounting it.  Line it up carefully. 
Slowly and gently lower the peeled back portion of the Rocker Trim piece on tot he surface.  DO  NOT press it down yet.  Make any minor adjustments.  Once you are satisfied with the fit press down along the whole surface firmly.

6.  Now peel about a foot or two and line up and press as you go, removing more liner and repeating the process.