DODGE VIPER RT/10  GAS CAP
 PART ACC-962007 All Polished  patent pending

INSTALLATION INSTRUCTIONS

Items Included:  1 x Gas Cap Cover, 1 x Adhesive Promoter packet

Notes:
(a)  Care must be taken when cleaning your gas cap cover since you can scratch it easily.  There may be some small black specks on the surface.  This is a tiny bit of excess glue.  You can remove this by wiping a clean soft cloth with a good quality glass cleaner or rubbing alcohol.

(b)  Leave the clear plastic shield on top of your gas cap until it is installed to prevent scratching the surface.

1.  Clean gas cap area first with soap and water to remove any dirt.  Then wipe thoroughly with household rubbing alcohol.  Let dry.

2.  Without taking the backing off - place the cap on top of your existing cap and line it up to get an idea of how it fits.  You may have to slightly bend the gap to fit the exact curve of your car.
Very Important:  Before you stick the cap on, ensure you see how to position it so it does not hit the car when the gas cap is opened.

3.  Carefully open packet of Adhesive Promoter included.  Keep it up so no liquid spills out when opening it.  Using the sponge from inside the packet carefully wipe (only) the area with promoter where you are going to stick the gas cap, i.e. all over the face of your cars existing gas cap’s surface.  You need to now install the cap right away while the Promoter is active.

4.  Peel the red liner off the back covering material without removing the front clear covering material on your new cap.

5.  Very carefully holding the cap just off the surface, position the new gas cap into position without pressing down.  Use the opening finger hump on the left side of your existing gas cap to line up your new cap.

CAREFUL: Once the new gas cap’s back touches the surface of  your car it is stuck permanently.

The cap actually is designed with a slightly larger in diameter than the factory cap, so there will be a very slight over hang. Make any minor adjustments.  Once it is in position set the cap down on top the existing cap lightly.  Make sure you can open your gas cap now.  Make final adjustments quickly. Then firmly press down over the surface of the cap for a permanent bond.  

6.  Remove the clear protective liner from the top of the new cap.

 

 
Ensure you mount the cap so that it has clearance when opened.   
 

TheViperStore.com a HotCarAccessories.com site