TheViperStore.com
Dodge VIPER SRT-10
(2003-2005)
Polished Stainless Steel Speaker Trim Set - 2pc
Part # ACC-971002
INSTALLATION INSTRUCTIONS
Parts Included:
1 x Large Speaker Circle Trim, 1 x Small Speaker Circle Trim, 1 x Test Strip, 1
x Adhesive Promoter Pen.
Your may
come with
a clear protective liner. If so, Do Not Remove until instructed to do
so.
VERY IMPORTANT - PLEASE READ ALL
INSTRUCTIONS BEFORE BEGINNING YOUR INSTALLATION! You must follow these
instructions or your new part(s) may not adhere.
If you remove the back read liner or scratch the surface of the trim it is
not returnable.
1. BEFORE YOU BEGIN YOU MUST FIRST PREP THE SURFACE IN ORDER
TO ALLOW ADHESION. You do this by scrubbing the entire area with
household Isopropyl Alcohol (or rubbing alcohol) found at most
grocery stores and all hardware stores. Scrub the are vigorously to
remove any hint of oil.
2. Once properly cleaned take the piece of test strip tape
included and remove a portion of the back red liner. Stick the test
tape strip to the area where you will be mounting your new trim. Test
several areas. If it is tacky and sticks then proceed to the next
step. If it is not sticking very well in any of the spots you tested
then re-clean the area until the test strip sticks to all areas.
3. Take your trim piece and
without removing the back red liner - hold it up to where it is to be
mounted. See how it fits. If the piece does not fit properly -
STOP. Call us.
Become familiar with the way it fits into place. Now peel off
the clear plastic top liner (if there is one).
4. Remove
the red back liner and hold the trim piece slightly above where it is to be
mounted. Do not touch it to the surface yet. Carefully maneuver
the trim to the exact spot and gently set it into place without pressing on
it. Make any final tiny adjustments necessary.
5. Now Push along the entire
surface starting in the center and working your way out.
Repeat
process for the other piece(s). Keep the trim clean with a mild glass
cleaner.
|