|
This Frame has opened up into a New Window
Dodge Viper SRT10 Convertible Wing
Instructions
Bolt-On Wing-Spoiler Application STEP-by-STEP
- ( Strips )
STEP 1.
After opening and inspecting the rear spoiler you can begin the
installation. Notice that the LED light and the pedestal gaskets come
pre-installed from the factory (pre-painted spoilers only), which will save
some time on the installation.
STEP 2.
Start by turning over the spoiler and setting it on a soft surface, to
prevent any scratches. Place the plastic locator T-strips into the mounting
holes on spoiler and LED brake light hole. TIP: A small piece of masking
tape is helpful in holding the T-strips in position temporarily.
STEP 3.
Place spoiler on closed Deck lid and align to proper position. A measuring
tape will ensure a "perfect" alignment. Measure from Left side tip of
Spoiler to front corner of trunk lid, then do same for Right side, make
equal. Then make sure side spacing is same.
STEP 4.
Using masking tape, secure locator T-strips to the Deck lid of the vehicle.
Simply remove the spoiler by lifting straight up leaving the T-strips
secured to the Deck lid.
STEP 5.
Raise Decklid a few inches, by placing object in Latch area, to hold lid
open before drilling. Using a 1/8" drill bit, drill thru the T-strip holes
and into the Deck lid. It is not necessary to drill through a double panel
on this particular application because we can utilize the factory openings
on the underside.
STEP 6.
Remove T-strips and using a 5/16" drill bit, drill thru the 1/8" hole in
step 5. If a "double panel" does exist, use a 1/2" drill bit to drill thru
the "inner panel". This allows the ratchet or nut driver to secure the screw
tightly against the upper panel.
STEP 7.
After de-burring all holes, apply small amounts of primer which will help
prevent rusting of the freshly drilled metal.
STEP 8.
Place spoiler on deck lid using supplied screws. Secure to the vehicle
using a ratchet or nut driver. Be sure to feed the LED light wire through
the pre-determined hole. Apply small amounts of silicone based caulk over
mounting screws as this will help prevent leaking, rusting, or loosening of
screws
STEP 9.
When installing a LED brake light it is recommended to splice into the 3rd
brake light in the vehicle and attach spoiler wires using electrical tape.
Step on the brake light to ensure proper wiring, simply switch the two
connections if spoiler does not light.
STEP 10.
Finish your installation by vacuuming any debris or metal shavings.
Reinstall any panels, mats or other items that may have removed earlier in
installation.
|
