DODGE RAM SRT10 THROTTLE CABLE SHROUD

PART # Special Order patent pending

INSTALLATION INSTRUCTIONS

PARTS INCLUDED:

1-Stainless Throttle Shroud

1-Washer Head Screw

1-White Socket

1-Chrome Screw Cap Cover 

Your new cover comes to you with a protective liner. Do not remove liner until installation is complete.

1. Place the cable shroud over the factory bracket and situate the cover so that the notch on the left side is snug against the plenum. Prop the cover so that it is nice and level while maintaining the contact with the plenum and mark the small hole location to the factory bracket. Remove the cover and pilot a 9/64^th hole at this mark. Attach the new cover by placing the washer head screw provided thru the white nylon screw cap socket and tighten the cover into place.

2. Snap the chrome screw cover over this assembly and remove the protective liner.

If any questions occur during installation please call American Car Craft at 727 861-1500.

CARE AND MAINTENANCE:

Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.