This
may work for you-
ATTENTION: You MUST HAVE one
working remote to add one more to the system.
If you do not have one working remote right now then these
instructions will not work.
You will have to have a Locksmith or dealership use a computer
to program the first
remote for you.
1. Using a working
keyless remote, unlock the vehicle and disarm the Vehicle
Theft/Security
System.
2.
Insert key into the ignition switch. Turn ignition to the RUN
position (as far as you can go without cranking engine).
3.
Using the working remote,
press and hold the UNLOCK button on the remote for 4 to 10
seconds.
4.
Within the specified 4 to 10 seconds, continue pressing the
UNLOCK button and then
press the PANIC button ( on the
programmed remote ) for 1 second and release both
buttons. A chime will sound to indicate that the remote
programming mode has been
entered ( allow 3 seconds for chime to sound ).
5.
Within 30 seconds of the chime, press and release the LOCK and
UNLOCK buttons
simultaneously then press and release just the UNLOCK button
on the same remote.
A chime will sound indicating the remote has been
programmed. Press and release
the LOCK and UNLOCK buttons simultaneously and then press
the UNLOCK button on
each new remote you wish to program at this time. A chime
will sound after each
additional remote is programmed.
6.
Turn the ignition OFF and remove key.
7.
Test Remotes
Note: If this does not work you
will have to have your local Chrysler dealer program it for you.
