DODGE Viper II Fuse Box Cover Instructions

PART # DVFB305

INSTALLATION INSTRUCTIONS

Your new Fuse Box Cover comes to you with a protective liner. Do not remove liner until installation is complete.

ITEMS INCLUDED:

1-Stainless Fuse Box Cover     2-Decorative Thumb Screws

Your new covers come to you with a protective liner. Do not remove liner until prompted by instructions.

1. Remove the two small factory bolts just below the fuse box. NOTE: These bolts will not be reused.

2. Place the new cover over the fuse box and check the shape and fit. Adjust by hand if needed you can do this by either squeezing the cover or spreading the cover in order to achieve a nice contoured and correct seating. Once you are satisfied with the fit simply remove the protective liner and fasten at the hole locations exposed earlier using the two decorative thumb screws provided.

If any questions occur during installation, please contact admin@theViperStore.com

Note: Care must be taken when cleaning your new cover. It is a good idea to lightly dust your cover with a clean soft cloth first in order to prevent any particles from scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free glass cleaner.