|
This Frame has opened up into
a New Window
DODGE VIPER II SIDE FENDER VENT GRILLES
PART #DVGV109 or DVGV109-A patent pending
INSTALLATION INSTRUCTION
Your new grille vents come
to you with a protective liner. Do not remove liner until installation is
complete.
ITEMS
INCLUDED:
2 - Stainless Vent Grilles 2 - Rivets and 2-screws
4 - Support brackets (certain kits)
2 - Stainless Brackets 2 - Adhesive Promoter Packs
-
Open the hood completely. You will notice a ridge at the very inside of
the hood where the inner structure meets the outer skin. Your new vent
grilles are designed to fit directly into this ridge at a diagonal angle.
In fact, the grille itself will only conform to this area in this way. The
first step is to prepare this groove by cleaning away any dirt and grime
that may have built up. Then scrub the ridge with household rubbing
alcohol.
-
Position the grille into this ridge to get a good look at just how it is
to be placed and how it will fit. The bottom of the grille should seat at
the bottom of the fender lip. Holding the grille in position mark the
location of the small hole in the top of the grille to the inner wall
fender and remove the grille. Using a 9/64th drill bit drill a
small hole where you just marked. Being ESPECIALLY CAREFUL NOT to POKE
through to the outer painted skin.
-
Once this area has been thoroughly cleaned swipe the area where the Vent
Grille touches the inner fender
with the adhesive promoter provided.
-
If you are comfortable on how the Vent Grille will vent and slightly bend
into position then peel the red release liner from the back of the grille.
Carefully reposition the grille over the hole you just made and set the
grille so that it sticks right into the groove. If done properly the
grille should stay in position by itself. At this time rivet the top of
the grille using the rivet provided.
Note: You may also use the
screws provided instead of the rivets if you do not h have access to a
rivet gun. If using the screws simply screw them into the hole so they
are tight. Do not over tighten.
-
You have been provided with a stainless bracket which is designed to
attach directly to the grille behind the badge over to the hood fender
wall. Scrub the two points of attachment with household rubbing alcohol
let dry then swipe once with the adhesive promoter provided. Then simply
peel and stick the bracket and set into position pressing firmly to both
areas to set.
-
Carefully lower the hood and adjust the edge of the grille so that you
achieve a nice contoured shape. If properly installed
the grille should not come into direct contact with the painted inner
fender. Remove protective liner.
-
Repeat steps 1-5 for opposite side.
Note:
Care must be taken when cleaning your vent grilles. It is a good idea to
lightly dust your grilles with a clean soft cloth first in order to
prevent any particles from scratching them. Then wipe (using a new clean
soft cloth) with a good quality streak free glass cleaner.
or
  
This Frame has opened up into a New Window
Copyright 2005 - 2025
The Viper Store a HotCarAccessories site
Not Affiliated with Dodge,
Chrysler or it's divisions
 
|
